To extract the headlight and install the same, begin by extracting the radiator grille that holds screws and extracting the grille. Then, take out the head light bulb trim ring by turning off the three screws and clockwising the ring with the support of the head light bulb. Do not knock over the headlight aiming screws in the housing beside the retaining screws. Pull the plug connector on the back of the bulb and remove the bulb. Attach the plug connector to the rear of the new headlight and install the headlight in the housing making sure that the bulb tabs fit into the slots. Next place the trim ring on top of the bulb and loosely attach the retaining screws and then turn the ring counterclockwise to hold it in place and tighten the three screws attaching it. And lastly, remove and re-attach the grille as well as check the headlight aim.