Genuine Mazda Millenia Hood

Mazda Millenia Hood Parts and Q&A

• Hood
  TBY3-52-300
  Q: How to remove and install the hood on Mazda Millenia?

  A:

  The process to install and take off the hood is to matchmark its position by first removing the retaining bolts. Assist in securing the hood, and then opening it and supporting. Indicate the location of the hinge and disconnect the windshield washer hose (where it existed). Through assistance, raise the hood, pull out the hood support, and pull out the hinge-to-hood bolts then detach the hood off the vehicle. To install, place the hood against the hinges and use the marks made earlier to align the hood then have it assisted and install the hinge-to-hood bolts and the hood support and bolts as well. Should it be connected, re-attach the washer hose, and screw all bolts firmly and make sure they are in place. To make adjustments to the alignment, the hood can be an up-and-down and side-to-side adjustment. To modify laterally, loosening of the attaching bolts, refitting the hood, and tightening the bolts again may be repeated. To make up/down changes at the rear, loosen the hood stop bolts, with a screwdriver turn the hood stop screws to the required height where they are in line with the fenders and then screw in the stop bolts, continuing again in a similar manner. It is necessary to align the hood, then lock the latch by removing the latch attaching bolts and positioning them as necessary and tighten. Take the locknut off the latch dowel and make sure that you set the dowel where it fits, so that the top of the hood is even with the fenders and lastly lock the dowel lockut with the required adjustments.