Genuine Mazda MX-6 Window Regulator

Mazda MX-6 Window Regulator Parts and Q&A

• Window Regulator
  GJ2159560B
  Q: How to lower the door glass and remove the door trim panel and water shield for the Window Regulator on Mazda MX-6?

  A:

  Reduce door glass and door trim panel and water shield. In case of power window models, remove the negative battery cable. On back doors eliminate the belt line molding. In models that have power windows, disconnect the motor connector. Adjust the position of the regulator (as needed) so that the bolts of the glass installation are visible through the service holes. On front doors, loosen the bolts and lift up and out of the door window opening the glass. Removal On rear doors, take off screw and bolt, push out the center channel, bring down the back of door glass, take off lift bracket on roller then lift glass and out of door including back quarter glass. Removing the bolt of installation, raise the regulator through the service hole in the door (both front and rear). In the case of power windows, detach and take out the motor by the regulator. Installation is the opposite of removal, which involves consideration of certain points like using soapy water on the quarter window channel to make the process of installation easy. In the case of power window models, the battery negative cable is attached; and the regulator is operated to the Down position and then the motor can be installed. Once installed, run the glass up and down the several times to make sure the glass is running lightly and smoothly, with the necessary adjustment of regulator bolts.