Q: How to replace car bulbs, including front turn signal bulbs and other vehicle light bulbs on 2008 Mazda Tribute?
A: To change front turn signal bulbs, loosen lug nuts, place vehicle on jackstands and remove front wheel. To repair the turn signal bulb, pry back the inner fender splash shield and pull out the bulb holder by turning it counterclockwise then removing. It is best to pull the bulb out and fit the new bulb by reversing the process. To replace the bulb in high-mount brake light bulbs on 2012 and earlier, unlock the screws that hold the assembly of the mounts, unconnect the electrical connector and disassemble the bulb holder assembly and the lens. In 2013 and later models, the high-mount brake light has non-replaceable LED bulbs. Removal of brake/tail/turn/back-up light bulbs To replace a bulb, rotate the socket counterclockwise, remove the assembly mounting screws, pull the assembly to disengage the locator pins and replace the bulb. In the case of the trunk lid mounted reverse lamp, simply remove the trim panels, the securing nut, and in order to remove the bulb, pry off the lens. The light bulbs in the license plates also depend on the model year; in 2007 and older, the pivot to the assembly is the liftgate, whereas in 2008-2012, it is the entire housing, and in 2013 and beyond it is the pivoting of the retaining tab to release the housing. In order to change the bulb socket, it is necessary to turn counterclockwise and remove it, but be sure that the new bulb is fitted. With side turn signal lamps, slide the housing back and pull off the wiring. Fog light bulbs involve lifting the car, unscrewing the splash shield fasteners, and unconnection of the wiring; the bulb will be removed differently on the 2012 and earlier models than the 2013 and later models. Finally, in the case of the interior/map reading light, one must loosen the lens using a pry tool, change the light bulb and reassemble everything in a reverse sequence.