The side marker light bulb and turn signal light bulb are both replaceable, remove the screws and lenses to locate the bulb, and push the bulb off the socket to replace the side marker or rotate the bulb counterclockwise to replace the turn signal. In order to change the ignition switch light, take off the steering column covering and then extract the bulb out of the socket and install the new bulb as necessary. In the case of the dome/map light, to remove the lens, it is best to hold the lens and push it down to take out the bulb by pushing it down. The optional overhead map light needs to have the light lens/button pried off using a small screwdriver after which the bulb should be replaced by simply holding onto the light and simply drawing it out of the socket. The bulbs of the instrument panel may be changed by removing the instrument cluster; turn the holder, pull it out of the panel and then take the bulb out of the holder. It has a radio illumination bulb with a twist-in holder that can be accessed by removing the radio. In the case of luggage compartment light, the bulb is removed by prying off the lens, then holding the bulb itself and pulling it out of the socket. In order to open the license plate housing, screws and housing of the license plate should be removed to obtain access to the light bulb. On the rear lights, you need to take out the inner trim panel, press the tabs and take off the light housing which will give you access to the tail, back up, and rear marker, and parking light bulbs, make sure the tabs fit back in place once the housing is reinstalled.