1987 Mazda B2000 Control Arm, Coil Springs, Steering Knuckle, Strut Housing

Control Arm, Steering Knuckle Installation and Repair Tips for 1987 Mazda B2000

• Q:

  How to remove and install the components of the lower Control Arm and Torsion Bar for 4-wheel drive front suspension on 1987 Mazda B2000?

  A:

  Removing and installing parts To install and remove parts, jack up the front end on jackstands and take off the wheel. Before removing, mark different parts, take off the lower ball joint, shock absorber and shock absorber bolt. Check wear, replace, and examine ball joint preload. To install it, use special torque requirements, lubricate splines, and reposition ride height, where required.
• Q:

  How to remove the Steering Knuckle and Spindle on 1987 Mazda B2000?

  A:

  In order to take off the parts, place jacks at the front end and then take off wheels. Inspect brake rotor of bearing play. Take off the caliper, locking hub and others. Separate the ball joints and take out the knuckle. Assemble, fit bearings and seals, fit and torque bolts, and test the bearing rotational effort. Lastly, install the caliper and wheels.