1993 Mazda B2200 Ignition Coil, Ignition Control Module

Ignition Coil, Ignition Control Module Installation and Repair Tips for 1993 Mazda B2200

• Q:

  How to remove and install the Ignition Control Module for DISTRIBUTORLESS IGNITION SYSTEM on 1993 Mazda B2200?

  A:

  The igniter can be removed and installed by first disconnecting the harness connector at the top. Then, take off the screws that are connecting and extract the igniter. Next, you will replace the igniter and screw it back on the connector of the harness and then reconnect the connector.
• Q:

  How to conduct primary and secondary circuit tests on an ignition coil in distributorless ignition system on 1993 Mazda B2200?

  A:

  In order to test circuits, turn ignition switch off, disconnect battery, and disconnect wiring harness of ignition coil. Check dirt or damage of terminals. Comparison of resistance between terminals and towers of spark plug wires and replacement of coils when the readings are beyond the acceptable limits. To install, screw the coil pack and use dielectric compound and then reconnect spark plug wires.