1988 Mazda B2200 Ignition Coil, Ignition Control Module

Ignition Coil, Ignition Control Module Installation and Repair Tips for 1988 Mazda B2200

• Q:

  How to test an Ignition Coil and what steps should be followed for proper resistance measurements and replacement in distributor ignition system on 1988 Mazda B2200?

  A:

  Connect an ohmmeter across the primary terminals and check resistance; if much higher, replace coil. Then check secondary resistance across the distributor side and center tower; replace if much higher. Check insulation between the negative primary and metal body; replace if low. If coil tests fine, replace igniter and pickup.
• Q:

  How to remove and install the Ignition Control Module for DISTRIBUTOR IGNITION SYSTEM on 1988 Mazda B2200?

  A:

  In order to install and delete the module, it is necessary to disconnect battery cables, taking off the battery. Next, loosen the electrical connector at the module, loosen the retaining bolt and the module. Insert the rivets into the slot, insert the module and use the bolt to fix the module into position.