To access the front turn signal and parking light bulbs on the driver's side headlight housing, remove the battery air inlet and the air filter housing air inlet duct. For the passenger's side, detach and set aside the power steering fluid reservoir. Turn the bulb holder counterclockwise to remove it from the headlight housing without disconnecting the electrical connector. Pull the bulb straight out of the holder for replacement, and installation follows the reverse order. For front side marker light bulbs in 2010 and earlier models, push the back of the side marker light housing forward to lift it out, disconnect the electrical connector, and pull the bulb straight out. Installation requires ensuring the hook end goes in first before snapping the housing in place. In 2011 models, if the bulb is not working, the entire side marker light assembly must be replaced. Detach the mirror glass and its holder, disconnect the electrical connector if equipped with heated mirrors, and remove the side marker while detaching the tab, with installation reversing the removal steps. For fog light bulbs, raise the front of the vehicle, remove the fasteners to pull back the inner fender splash shield, disconnect the electrical connector, and turn the fog light bulb counterclockwise to remove it. Insert the new bulb and turn it clockwise to lock it in place, with installation otherwise reversing the removal. For the center high-mounted brake light bulb in 4-door models, remove the trunk lid trim, rotate the bulb holder counterclockwise to pull it out, and remove the bulb straight from the holder, with installation reversing the removal. In liftgate models, open the liftgate, pry out the upper section of trim, and follow the same steps as for the 4-door models. For taillight bulbs, fold back the trunk floor carpeting, reposition the flexible trunk side trim panel, rotate the taillight bulb socket counterclockwise to remove it, and pull the bulb straight out. Installation is the reverse of removal. For license plate light bulbs, unclip the housing, rotate the socket counterclockwise to remove it, and pull the bulb straight out, with installation reversing the removal. For interior map light bulbs, pry the housing down to disengage the clips, disconnect the electrical connector, rotate the socket counterclockwise to remove it, and pull the bulb straight out. Installation follows the reverse order. For overhead light bulbs, pry off the lens, pull the bulb straight out, and installation is the reverse of removal.