How to remove and install a Clutch Release Bearing on Mazda Protege?

Question

Accepted Answer

In the removal of the component, the negative cable to the battery should be first disconnected before the removal of the transaxle. The second step is to remove the bearing on the lever by pulling of the retention spring, and then removing the lever by pulling off the clutch release lever off the ball stud. To check, you take the bearing and hold it with the outer race, then twist the inner race, pressing on it, it is supposed to roll easily and when it does not or is noisy then change it. Wipe a clean rag and ensure no damage, wear and cracks and do not immerse in a solvent because it is lifetime sealed. Inspect the release lever as well to check whether it is crooked or not. To install, apply a smear of high temperature grease to the inner groove of the release bearing, and then apply a thin film of the same grease to the transaxle input shaft splines and the front bearing retainer. Grease the release lever ball socket, lever ends, and release cylinder push rod socket with high temperature grease and then fit the release bearing to the release lever. Install the release bearing and install the end of the release lever through the hole in the clutch housing and push the clutch release lever onto the ball stud until firmly seated. Lastly, grease the release bearing side where it will be in contact with the pressure plate diaphragm fingers with a light film of high temperature grease and complete the installation by reversing the removal process.

Genuine Mazda Protege Clutch Release Bearing

4 Clutch Release Bearings found

Mazda Protege Bearing Part Number: LF01-16-510

Mazda Protege Release Bearing Part Number: FE84-16-510

Mazda Protege Release Bearing Part Number: FP01-16-510

Mazda Protege Release Bearing Part Number: G561-16-510C

Mazda Protege Clutch Release Bearing

Mazda Protege Clutch Release Bearing Parts and Q&A

Related Mazda Protege Parts

Browse by Year